!
NOTE:
A 15 Amp, 120 Volt alternating current (VAC) circuit is
required. A dedicated circuit is preferred but not essential in all
cases. A dedicated circuit will be required if, after installation, the
circuit breaker trips or fuse blows on a regular basis when the
heater is operating. Additional appliances on the same circuit may
exceed the current rating of the circuit breaker.
WARNING:
Ensure the power cord is not installed so that it is
pinched or against a sharp edge and ensure that the power cord is
stored or secured to avoid tripping or snagging to reduce the risk of
fire, electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local
building codes and other applicable regulations to reduce the risk of
fire, electric shock and injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce
the risk of fire, electric shock or injury to persons, always use a
licensed electrician.
(No assembly required for the flat wall mantel)
Corner Mantel
Assembly
Assemble the
1.
top of the mantel
to the rear
support using
the supplied
hardware.
Using the
2.
supplied
hardware
assemble the
top and rear
support
assembly to the
main fireplace
body (Figure 2).
4
Figure 2
Rear Support
Main Body
Mantel Top
Hardware
www.sylvane.com 1-800-934-9194
