Electra 88900, Assembly And User'S Manual

Page: 9 / 27

8
ASSEMBLY INSTRUCTIONS
Pedal Crank Arm
Pedal
Hexagonal Key
Mirror
Nut
side of the PHANTOM 4™ (your left side as if seated on the
PHANTOM 4™). The inside surface of the crank arms are labeled "L" and "R" like the pedals. The
Left pedal has reverse threading meaning it tightens by turning it to the left (counter-clockwise).
The Right pedal has normal threading and tightens by turning it to the right (clockwise). After
threading the pedals into the crank arms as far as possible with your fingers (to avoid cross
threading), tighten them snugly with an adjustable wrench.
REARVIEW MIRRORS
(SOLD SEPERATELY)
After unpacking your PHANTOM 4™ there is minimal assembly to be completed. Assembly
consists of attaching the pedals to the PHANTOM 4™ and attaching the rearview mirrors.
PEDALS
Locate Pedals (Set of 2) The pedals are labeled
left and right near the threads. They are not
interchangeable. The left pedal goes into the
threaded hole on the left crank arm on the left
You have now successfully assembled your PHANTOM 4™!
If you have any questions about assembly please call :
Electra Customer Service / Technical Support
Toll-Free at 1-888-467-1234 M-F 10-am - 9pm EST.
Locate the chrome mirrors included with your PHANTOM 4™.
These have threaded ends and include a nut. With the
Hexagonal ("Allen" or "Hex" wrench) Key provided in your
PHANTOM 4™ toolkit, remove the screw and nut as shown in
the pictures. Once the nut is removed from the threaded end
of each mirror, insert the threaded end of the mirror as shown
on picture at left. Then screw the nut onto the mirror's
threaded end as shown on picture below.
The mirror needs to be
tightened fully for assembly
to be safe. Repeat the
process for the other mirror.
Once mirrors are installed,
they should look like the
picture on left. Make sure to
adjust the mirrors before
use so that you can see
behind you as you ride.