4
• If the hood is being installed so that the air is vented outside, there MUST
be adequate ventilation of the room when the hood is used at the same
time as appliances burning gas or other fuels – use of the hood may be
dangerous as it could draw back the fumes from the other appliances which
would otherwise be vented outside. If adequate ventilation can only be
ensured via an open window, a window contact switch should be fitted,
(available from good DIY stores or Builders merchants) which will then
ensure the hood may only be operated when the window is sufficiently
opened. Please note – the above does NOT apply if the hood is only used
in recirculation mode with charcoal filters.
• Regulations concerning the discharge of air have to be fulfilled.
• If used in recirculation mode, the charcoal filters trap odours and must be
replaced at least once a year depending on how frequently the cooker hood
has been used.
• The installation instructions for range hoods with accessible metallic
enclosures of class II construction shall include details that indicate the
location and maximum permitted lengths for any fixing or mounting screw
or other fixing device that penetrates into the range hood to attach an
accessory such as a facia or duct fitting.
• Where fixing or mounting screws, or other fixing devices are used, that
penetrate into the range hood with an accessible metallic enclosure of class
II construction, to attach an accessory, the instructions shall indicate the
required location of these screws or fixing devices and include the
substance of the following warning.
• For safety reason, please use only the same size of fixing or mounting
screw which are recommended in this instruction manual.
• Warning: Failure to install the screws or fixing device in accordance with
these instructions may result in electrical hazards
• Regarding the instructions for the bulb changing, refer to the section “bulb
changing”. ILCOS D code for this lamp is: DBR-2/65-H.
CAUTION: Accessible parts of the hood can become very hot during
use with cooking appliances, whether in use or not, due to heat rising
from the hob. Sufficient cooling time should be allowed before
touching either the housing or the grease filter(s)
