KPA-15
5
Installation Procedures:
1.
Put KPA-15 in Test mode by entering “0000” (default PIN code), then press
＊
. KPA-15 will sound 1 long beep
and the Green Active LED will steadily flash.
2.
Adding KPA-15 into the Control Panel:
a.
Put the Control panel into /- menu and select the Add Devices sub menu.
b.
Press
＊
and then 1 when requested. KPA-15 and Control Panel will beep once.
c.
Refer to the operation manual of your control Panel under the section of Device +/- to complete the
learn-in process.
3.
After the KPA-15 is learnt-in, put the Control Panel into Walk Test mode, hold the KPA-15 in the desired
location, press the
＊
then 1 button to confirm this location is within signal range of the Control Panel.
4.
When you are satisfied that the KPA-15 works in the chosen location, you can proceed with mounting the
KPA-15 following the steps described below (see Mounting KPA-15).
5.
Setting the Pin Code:
a.
Press
＊
then 6, a long beep will be sound.
b.
Enter 0000 (default PIN code)
c.
Press
, KPA-15 sounds a long beep.
d.
Enter your new 4-digit code.
e.
Press #, KPA-15 sounds a long beep.
6
6
.
.
Press
twice to exit Test mode and the installation is completed.
Mounting the Keypad:
To mount the Keypad:
1.
Remove the 2 slide-out sections of front cover.
2.
Using the 2 mounting holes as a template, mark off the positions in the most appropriate place.
3.
Insert the wall plugs if fixing into plaster or brick surface.
4.
Screw the Keypad onto the wall plugs.
5.
Replace the 2 slide-out sections.
