12
EN
Hot-chocolate preparation
• Place the tank (5) in the base (8).
• Install the required tip inside the tank (5).
• Pour milk into the tank in the volume not exceeding the maximum level -
• Press the button (8) once. Then add the powdered chocolate or the finely crushed solid
chocolate.
• Place the lid (1) with the sealing gasket.
• Press the button (8) three times. The control light
will go on and the heating process
will start.
• The appliance will switch off automatically, and the control light will go off. The appliance
may be turned off at any time with the button (8).
• Then remove the lid (1).
• While holding the appliance by the handle (3), remove the tank (5) from the base and
pour out the milk to a cup.
NOTE. The solid chocolate must be finely crushed (preferably grated or blended).
Too-large pieces can block the attachment (2).
After use, wait for about 2 minutes for the thermostat to reset. This time may be shortened
when cold water is poured into the tank. Dry clean the appliance before its use.
CLEANING AND MAINTENANCE
• Clean the appliance immediately after use and cooling down.
• Before cleaning, turn off the appliance with the button (8), disconnect from the power
supply and wait to cool down.
• Never immerse the base (6) in water, and do not rinse under running water.
• The external surfaces may be cleaned with a damp cloth.
• Wash the elements (1), (2) in warm water with addition of washdish, use a soft sponge
and rinse under running water.
• Do not use abrasive agents, cleaning powders, acetone, alcohol, etc.
• The elements (1), (4) may be washed in a dishwasher, placed on the upper shelf.
Make sure that they are placed away from the heating element. The maximum
temperature is 50°C.
ENVIRONMENT PROTECTION
• the device is made of materials which can be reused or recycled.
• the device should be handled to a special point which deals with collecting and recycling
of electric and electronic equipment.
GUARANTEE
• the device is designed to be used in households.
• not for professional use.
• the control lamp is not subject to guarantee.
• the guarantee expires when device is used improperly.
Summary of Contents for Spin SI1050
Page 43: ......