Eldom Cube KS200, Instruction Manual

Page: 18 / 64

18
Caution! When the ice container is full, immediately remove the ice. Do not overfill the
ice container.
TIPS
- If the appliance will be used after a long time, the water pump may not pump a sufficient
amount of water due to an air lock. In this case, the “no water” indicator “ C ” is activated.
To fix the problem, press button “ D ” again, and then the ice machine will come back to
regular operation.
- Always use fresh water before ice-making after installation or after a long period of
downtime.
- If the compressor stops for any reason, such as a shortage of water, too much ice, power
failure, etc., do not start the unit immediately, but wait 3 minutes and then restart it.
- In the event of a power failure due to the power cord being disconnected or the power-
off button being pressed during the ice-making cycle, small pieces of ice may form and
settle in the automatic scoop attached to the container (8) , causing a jam. In this case,
disconnect the unit from the mains supply and remove the ice cubes by gently pushing
the scoop backwards. Then connect the ice machine to the mains supply and restart.
CLEANING AND MAINTENANCE
Before cleaning, turn the appliance off and disconnect it from the mains supply.
- Pull out and empty the ice container (10) .
- Empty the water tank (6) - To do so, pull the appliance slightly forward, place a container
underneath it, then remove the silicone plug (11) on the bottom of the container (6)
and allow the water to drain.
- The appliance’s internal walls, the container for ice-making (8) , the nozzles (7) , the ice
container (10) and the scoop (12) should be cleaned after each use.
- Use a diluted solution of water and vinegar to clean the inside and outside of the
housing. Rinse thoroughly with water before reuse.
- Clean the ice container (10) and the scoop with a mild detergent and rinse thoroughly.
- Do NOT use any chemicals such as acids, petrol or oil for cleaning.
- Check the ventilation openings in the housing for clogging at each cleaning.
- Do not use mechanical or other means to accelerate the defrosting process.