Keep the unit away from flammable materials such as curtains, furniture, clothing and
other similar at least at 50 cm. (See Figure 1). Do not use the convector in areas
where are used or stored flammable or combustible substances (including gases and
aerosols)! Do not use the convector in areas with flammable atmospheres! There is a
great danger of fire and explosion!
Do not leave the unit turned on for a long time unattended! Switch off the unit from the
mains whenever you do not use it for a long time (how to use the Anti-freeze function
please refer to the section How to use the appliance). Make sure the appliance is
disconnected from the switch before unplugging the power cord!
Do never move the convector while plugged in, when running or hot! When moving
use the handles for carrying (pos. В on Fig. 3).
Never place the power cord on the appliance while it is running or hot! Do not use the
cord to move the appliance, do not crush it, and do not pass it over sharp edges!
ATTENTION!
The appliance should NOT be positioned in the immediate vicinity of
mains sockets Fig. 5.
EN
EN
ENVIRONMENTAL PROTECTION
This appliance is marked according the Directive
on waste electrical and electronic equipment (WEEE)
. By ensuring correct disposal of
this appliance you shall prevent potential negative consequences for the environment and human health, which could otherwise be
caused by inappropriate waste handling of this product.
The symbol
on the product, or on the accompanying documents indicates that this appliance may not be treated as household
waste. Instead it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal
must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment,
recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you
purchased the product.
HEATER TECHNICAL DESCRIPTION
The electric convector heater is a household appliance intended to heat air in living rooms and maintain a specified temperature.
See
page 2.
APPLIANCE INSTALLATION
The heater installation must strictly comply with standards and rules in force in the country.
џ
Carefully remove the convector from its packaging and store the packaging in a convenient place.
џ
Do never use the heater without the supports for floor mounting. There is risk of fire!
џ
Before turning on the heater for the first time, you need to install the supports as shown in Fig. 2. Place the convector lying and put the
supports at its bottom, making sure that the power cord is put through as prescribed in the instructions and does not interfere with the
tightly fitted together unit elements. Fix firmly the supports - h
ook the supports in the openings and use the
supplied screws
(
one
screw for each support)
. Sloped openings should point to the front panel of the appliance.
џ
Place the unit in a vertical operating position and make sure that the supports are installed properly before connecting it to the mains.
џ
The convector power cord plug can only be connected to a protected single phase power outlet with voltage 230 V~.
џ
Convector heater should not be placed immediately in front of or under power outlets (sockets). The socket where the unit is
switched on must always be easily accessible to allow plug disconnection as quickly as possible when needed. Fig 5.
џ
When installing the appliance it is necessary to comply with the minimum prescribed distances from various obstacles and
surrounding objects as shown in Fig. 1.
џ
Do not install the appliance in places with compulsory draft, which can disrupt the control settings (under natural or forced ventilation
apertures, fans, etc.).
џ
When installing the heater on locations of high altitudes take into account that it may impact the temperature of the outlet air (by
о
increasing it with about 10 C when the altitude changes with 1000 m)
14
