©
2013 eldoLED. All rights reserved. V2.4
More documentation and eldoLED’s terms and conditions are available at www.eldoled.com.
Pay attention when connecting the LED groups:
• polarity reversal results in no light output and often damages the LEDs
• com and - of different groups damages the driver
LEDcode / NTC
2 LED groups,
1 control channel
2 LED groups,
1 control channel
{
{
2
9 mm
0.35 inch
1
+
-
0.5-1.5 mm
2
AWG 20-16
+
-
+
-
DALI
{
N
L
VAC
120-277
{
Wiring diagram DUALdrive 1060/S (DL1060S1)
WARNING: Risk of electrical shock. May result in serious injury or death. Disconnect power before servicing or installing.
CAUTION: The device may only be connected and installed by a qualified electrician. All applicable regulations, legislation and build-
ing codes must be observed. Incorrect installation of the device can cause irreparable damage to the device and the connected LEDs.
120-277VAC
The driver accepts a universal mains voltage input of 120-277VAC,
50/60Hz.
DALI
Use these connectors to connect the driver to a DALI network. Always
combine a DA+ and DA- connector for either data input or data output.
LED wire length
Maximum wire length from LED driver to LED engine at full load:
LED groups
Indicates the location of the connectors to which you can connect your
LED groups. The four LED groups are controlled over two control
channels: DALI ballast 1 consists of LED group 1 and 2, and DALI bal-
last 2 consists of LED group 3 and 4.
Output voltage vs output current for 4 outputs with symmetrical load
Vf
typ
is 57V, LED current ranges from 200mA - 1050mA
LEDcode/NTC
Use these connectors to connect a 47k
Ω
NTC thermistor for closed
loop LED engine temperature control.
AWG value
20
19
18
17
16
Distance (m)
14
18
22
28
36
Distance (ft)
45.9
59
72.2
91.9
118.1
Please observe voltage drop over long wire lengths.
Longer wire lengths increase EMI susceptibility.
0
1050
420
200
830
0
60V
30V
mA
Vf
