5. BATTERY REPLACEMENT
1.
Open
key fob’s
enclosure.
2. Remove the old battery from the battery slot.
3. Insert the new battery according to the appropriate po-
larity of the battery.
4. Battery is replaced.
6. SAFETY INSTRUCTIONS
Please read and follow these safety guidelines in or-
der to maintain safety of operators and people around:
• DO NOT use the system where it can be interfere with
other devices and cause any potential danger.
• DO NOT use the system with medical devices.
• DO NOT use the system in hazardous environment.
• DO NOT expose the system to high humidity, chemical
environment or mechanical impacts.
• DO NOT attempt to personally repair the system.
ATTENTION:
Only CR2450 3V or CR2320 3V (with
specially adapted battery holder) battery can be used.
Install only new, high quality and unexpired batteries.
ATTENTION:
In order to avoid fire or explosion haz-
ards, special care must be taken when connecting posi-
tive and negative battery terminals. Dispose old bat-
teries only into special collection sites. Do not charge,
disassemble, heat or incinerate old batteries.
NOTE:
The battery status can be monitored in real-
time using
ELDES Utility
software.
7. RESTORING DEFAULT PARAMETERS
1. Launch Eldes Utility software, go to Peripheral Devices
section, remove previously added key fob by clicking
Re-
move
, located next to the paired wireless device icon.
2. Press and hold
and
buttons simultane-
ously.
3. Hold those buttons pressed (approx. for 10 seconds) un-
til LED indicator (red) and the buzzer provide several short
flashes and beeps simultaneously.
4. Release the buttons.
5. Default parameters are restored.
8. ADDITIONAL INFORMATION
Warranty procedures
Warranty and out of warranty service should be obtained
by contacting the system integrator/dealer/retailer/ e-
tailer or distributor where the customer purchased the
product. When requesting for service, the proof of pur-
chase and the product serial number must be provided.
The return of the defective product should be strictly
through the original route of purchase, and the custom-
ers shall pack the product appropriately to prevent the
returned product from suffering in the transportation.
Technical support
In order to ensure continuous and proper operation of Key-
BoB device and uninterrupted service, it is the responsibil-
ity of the User to make sure that: (I) the product is properly
installed, and (II) there is constant internet or GSM connec-
tion and electrical supply (low battery must be replaced in
time). If you experience difficulty during the installation or
subsequent use of the system, you may contact ELDES, JSC
distributor or dealer in your country/ region. For more infor-
mation see eldesalarms.com
Limited Liability
The buyer must agree that the system will reduce the
risk theft, burglary or other dangers but does not provide
guarantee against such events. ELDES, JSC will not assume
any responsibility regarding personal or property, or rev-
enue loss while using the system. ELDES, JSC will also as-
sume no liability due to direct or indirect damage or loss,
as well as unreceived income when using the system, in-
cluding cases, when the damages arise due to the above
mentioned risks; when due to breakdown or malfunction
the user is not informed in a timely manner about a risk
which has arisen. In any case, the liability of ELDES, JSC, as
much as it is allowed by the laws in force, shall not exceed
the price of acquisition of the product.
Manufacturer Warranty
ELDES, JSC warrants this system only to the original pur-
chaser and only in case of defective workmanship and
materials under normal use of the system for a period of
twenty four (24) months from the date of shipment by
ELDES, JSC (Warranty Period). Warranty obligations do
not cover expandable materials (power elements and/or
batteries), holders and enclosures. The warranty remains
valid only if the system is used as intended, following all
guidelines outlined in this manual and in accordance with
the operating conditions specified. The warranty is void
if the system has been exposed to mechanical impact,
chemicals, high humidity, fluids, corrosive and hazardous
environments or
force majeure
factors.
Consumer protection laws
FOR CONSUMERS WHO ARE COVERED BY CONSUM-
ER PROTECTION LAWS OR REGULATIONS IN THEIR
COUNTRY OF PURCHASE OR, IF DIFFERENT, THEIR
COUNTRY OF RESIDENCE, THE BENEFITS CONFERRED
BY THIS WARRANTY ARE IN ADDITION TO ALL RIGHTS
AND REMEDIES CONVEYED BY SUCH CONSUMER
PROTECTION LAWS AND REGULATIONS. This war-
ranty grants upon you specific legal rights, and you
may also have other rights that vary by country, state
or province
.
Copyright © ELDES, JSC,
2020. All rights reserved
It is strictly forbidden to copy and distribute the
information contained in this document or to
pass thereof to a third party without an a priori
written authorization obtained from ELDES,
JSC. ELDES, JSC reserves the right to update or
modify this document and/or related products
without an a priori warning. ELDES, JSC hereby
declares that the mentioned product KeyBoB
(certified as EWK3) is in compliance with the es-
sential requirements and other relevant provi-
sions of the Directive RED 2014/53/EU, Annex
III. The certificate is available at:
www.eldesalarms.com/keybob
The WEEE (Waste Electrical and Electronic
Equipment) symbol on this product (see
left) means it must not be disposed of in
household waste. To prevent possible harm
to human health and/or the environment,
you must dispose of this product in an ap-
proved and environmentally safe recycling
facility. For further information contact
your system supplier, or your local waste
authority.
