Status Indication
If the window handle is twisted while the win-
dow handle contact is activated, a warning beep
sounds for approx. 1.5 minutes. After this, the win-
dow handle contact is deactivated automatically.
To shut off the warning beep, keep the button
pressed until the beep has finally stopped.
Attention: Now the window handle is deactivated
and can be reactivated manually immediately af-
ter closing the window or automatically after 10
seconds..
UM92181B 1017 GB
Diposal
Waste electrical products and batteries may
not be disposed with household waste!
Dispose the waste product via a collec-
tion point for electronic scrap or via your
specialist dealer.
Dispose used batteries in a recycling bin
for batteries or via the specialist trade.
Put the packaging material into the
recycling bins for cardboard, paper and
plastics.
Warranty
Within the statutory warranty period we undertake
to rectify free of charge by repair or replacement
any product defects arising from material or pro-
duction faults.
Any unauthorized tampering with, or modifications
to, the product shall render this warranty null and
void.
Conformity
Hereby, ELDAT GmbH declares that the radio
equipment type RTS26 is in compliance with
Directive 2014/53/EU.
The full text of the EU declaration of conformity is
available at the following internet address:
www.eldat.de
Service
If, despite correct handling, faults or malfunctions
occur or if the product was damaged, please con-
tact your retailer or the manufacturer.
ELDAT GmbH
Im Gewerbepark 14
15711 Königs Wusterhausen
Germany
Phone: + 49 (0) 33 75 / 90 37-310
Fax:
+ 49 (0) 33 75 / 90 37-90
Internet: www.eldat.de
E-Mail: [email protected]
Battery Check
The battery voltage is monitored cyclically. Once
the battery is discharged, the red LED briefly
blinks red 2x at an interval of approx. 10 seconds.
Please exchange the battery now (see section
„Start-up“).
An undervoltage telegram is also sent. This can
be evaluated by the alarm signaller RTRP02.
If the voltage drops further, the window handle
contact deactivates itself. An alarm will no longer
be sent in this case.
Trouble Shooting
If the alarm annuciator does not react to the trans-
mitter:
- Exchange the battery of the RTS26 or make
sure that the polarity of the battery is correct.
- Check that the wireless connection at the
installation site is not impaired between the
transmitter and the alarm annuciator.
- Teach the transmission code to the receiver
again.
- Other wireless devices using the same fre-
quency or working in direct proximity may in-
terfere with the device.
Signal tone
approx.
1.5 min
