INSTALLATION
E-TRIP
®
Version: 2004/08/16 Order No.: 9526
Page 14
3.5 Installation of the Onboard Unit
Safety precautions :
Upon device installation make sure to keep a
minimum distance of 20 cm between the radio
antenna(e) and the workplace.
Any application of the device other than for its
contractual use may cause not only property
damage. Therefore always make sure to apply
our product only for the intended use !
During installation and connection please observe the
following safety precautions:
•
Disconnect negative pole of the battery!
Observe the safety instructions from the respective car
manufacturer. Note that, upon disconnecting, devices with
volatile memory will lose their information. Therefore it is
necessary, before disconnection, to write down all relevant
data and to notify the car owner that there may be need for
reprogramming.
•
When drilling holes, make sure not to damage any car parts
or electric wires.
•
The cross section of both positive and negative cable must
not be less than 0.5 mm².
•
Improper installation may cause interferences with the
Onboard Unit and other electronic systems of the vehicle.
•
E-TRIP shall be connected to the in-car outlets as
recommended by the car manufacturer only through the
cable set provided as part of the supply.
