IF101 2Q/4Q
ELBY Designs - Laurie Biddulph
9 Follan Close, Kariong, NSW 2250, Australia
[email protected]
http://www.elby-designs.com
1 of 3
Construction Guide
Revision 1.02
June 27
th
, 2018
Page 1: ...IF101 2Q 4Q ELBY Designs Laurie Biddulph 9 Follan Close Kariong NSW 2250 Australia elby designs bigpond com http www elby designs com 1 of 3 IF101 2Q 4Q Construction Guide Revision 1 02 June 27th 2018 ...
Page 2: ...t value of all components and General Construction Notes for general PCB assembly guidelines You are advised to check all of these documents on our website to ensure you have the latest copy 1 Assemble the Carrier Board assembly 3D Model 2 Fit all components to the boards following normal assembly guidelines except for all the jack sub assembly 3 Mount the jack sub assembly to the Column 2 board a...
Page 3: ... counter clockwise 3 Turn the X LEVEL knob fully clockwise 4 Connect a 200Hz 10VAC triangle wave to X IN 5 Adjust the BIAS knob to just below the point where the VCA starts to turn on This is called the threshold point Adjust the Y balance 1 Leave the BIAS control at the threshold point 2 Set MODE to 4Q 3 Turn the Y LEVEL knob fully counter clockwise 4 Turn the X LEVEL knob fully clockwise 5 Set X...
