15
Programming additional equipment for the 207C circuit board
LEB Radio-keypad programming
1. Move the jumper shown in Fig. 2 to A.B from B.C. This will activate the unit
2. Install the keypad in location. Do not overtighten the screws. Overtightening can distort the pad and leave the
keys inoperative
3. Dial in the following numbers to set the keypad to standard 20 mode. Dial in the numbers exactly as quoted
here and ignore that the unit does not bleep every time a button is pressed during this procedure.
4. Dial in,
00000 OK 99999 OK 5
5. Enter radio code programming (for the START control).
On the 207C panel
,
press and release the P3 button
(PROGR
) button. The LED DL6 will start to flash. Dial in the numbers of your choice, (max5) and end with OK.
The DL6 will go out. Dial in the same numbers again and end with OK, the gates should open.
6. Enter radio code programming (for the PEDESTRIAN control).
P3 button
(PROGR
) button twice; LED DL6 will
start to flash quickly. Dial in the numbers of your choice, (max5) and end with OK. The DL6 will go out. Dial in
the same numbers again and end with OK, the pedestrian gate should open.
SILICONE SEAL AROUND SCREW
HOLES AFTER INSTALL
Drill a small weep hole here to let out
any moisture.
