39
Manifold
male
pipe fitting
Inlet pipe
Hose holder
for LPG
Hose clamp
(not supplied)
LPG
Rubber hose (not supplied)
for LPG connection
(internal diameter 6 mm)
1/2” G cylindrical
(ISO 228-1) male
1/2” G cylindrical
(ISO 228-1) female
Sealing
washer (#)
(#) If not already fitted on the inlet pipe,
it is supplied with the appliance in a
separate kit
Fig. 8.3
GAS CONNECTION WITH RIGID PIPES OR A FLEXIBLE PIPE
The gas connection is made up of:
•
the terminal fitting of the inlet pipe (right-hand or left-hand);
•
sealing washer.
Important!
If fitted, remove the hose holder from the terminal fitting of the inlet pipe.
When connecting the cooker to the gas supply with rigid pipes or a flexible pipe,
make sure that
•
you use rigid pipes or a flexible pipe complying with applicable local regulations. The
flexible pipe shall be of the correct construction for the type of gas being used.
•
if compression fittings are used, you tighten them firmly using two spanners (fig. 8.4).
•
the connection with rigid metal pipes does not cause stress or pressure to the gas piping.
•
the flexible pipe is not under tension, twisted, kinked or too tightly bent, neither while
the appliance is in use nor while it is being connected or disconnected.
Gas connection with rubber hose holder
Note: if not already fitted on the inlet pipe, the hose holder is supplied
with the product in a separate kit; if not supplied with the appliance
it can be purchased by contacting the After-Sales Service.
(Important: to be used ONLY IF PERMITTED by the local applicable regulations)
Summary of Contents for N96 EX 780
Page 23: ...23 S F C T Fig 6 2 Fig 6 3 A B T S Fig 6 4 Fig 6 5 Fig 6 6...
Page 49: ...49...
Page 50: ...50...
Page 51: ...51...