4
Preparing the rangehood for installation
Ensure the overhead cabinets are built according
to Fig.7 (below).
Before drilling any holes, check that the area
behind the surface to be drilled is clear of any
electrical cables or pipes etc.
Ducted installation
If the rangehood is to be installed as a
ducted hood:
1
Remove the appropriate knockout to suit top
venting, as shown in Fig.4
2
Do not remove Cover Tape “A”. See Fig.4. This is
removed for recirculating only.
Mounting the rangehood
Warning!
Failure to install the screws or fixing device in
accordance with these instructions may result in
electrical hazards.
The rangehood can be mounted from the top.
Before commencement, unpack the rangehood
and check that it functions correctly.
Mounting to underside of cupboard
Fix the rangehood to a shelf mounted at the
right height in your wall units, by drilling 4 holes,
6 mm in diameter, (see Fig.6) and fixing with
the 4 screws supplied (found in the bag labelled
“TOP FIXING”). When installing the rangehood
the space between the product and the wall shall
be covered with the adjustable lateral and rear
spacer supplied (Fig.5 and Fig. 6).
453
33
15
210
203
Ø120
Wall
Cupboard
Door
For top ducting cut hole to suit size
Drill 6 mm holes
Fig.8 Mounting to
underside of cabinetry
Installation instructions
Fig.4 Preparing for install
Fig.5 Spacer Lateral
40
Fig.7 Panel heights
Screw shall be fixed into
lower face of the hood
Fig.6 Spacer Rear