Elba EWF-E7152D, Owner'S Manual

Page: 3 / 17

Distributors decline all liability for not following above instructions or some improper operations
which caused personal injury and property loss.
3. INSTALLATION
3.1 Before the installation

Please check the products and make sure there is no damage on the appliance.

The appliance door is level, and you can open and close the appliance door flexibly.

Specification on the marking plate is in compliance with the regulations.

If the appliance appears in an abnormal way, do not install and unplug the power supply
before contacting the authorized service center.

Do not attempt to repair or service the appliance by yourself. Repair or maintenance
should only be carried out by a qualified technician or the authorized service center.

This appliance must be installed only by qualified technician or the authorized service
center. Manufacturer declines all responsibility for improper installation, which may harm
persons and cause damage to the property.

The AC power supply should be supplied with 220-240V, 50/60Hz with minimum 13A
distribution circuit fuse or circuit breaker.
3.2 Installation of the appliance
The material of the surroundings should be insulated, and the clearance between the edge of
the cabinet and the appliance should be over 100mm for ventilation.
Remove the transport bolts

Before using the appliance, transport bolts must be
removed from the rear of the appliance.

Loosen all bolts with a spanner and remove them.

Stop the holes with transportation hole plugs.

Keep the transport bolts properly for future use.
Adjust the bottom legs

When positioning the appliance, check if the legs are closely
attached to the appliance. Otherwise, please turn using hand
or spanner and tighten the nuts with spanner. Make sure the
appliance is in level with the ground and not move around
when pressed on top.
Connect the inlet and outlet pipe

Connect the elbow to tap and fasten it clockwise.

Connect the other end of inlet pipe to the inlet valve at the rear
of the appliance and fasten the pipe tightly clockwise.

Position the pipe as shown in the figure.