OPERATING THE APPLIANCE
1. After assembling the appliance, connect the plug into the wall outlet.
2. Power on the appliance and the light indicator will be on (in red).
WARNING:
Before power on the appliance, make sure the control switch is turned to speed “0” (no
power).
3. Turn the switch either to speed ‘1’ or ‘2’ depending on the type of fruits or vegetables that is being
extracted. Soft fruits or vegetables such as berries, melons, cucumbers, tomatoes, etc, should be
extracted on speed “1”. Harder fruits and vegetables such as apples, celery, carrots, etc. should be
extracted at speed ‘2’.
WARNING:
Never put any fruits or vegetables in the feeder tube until the appliance is power on.
4. Insert the fruits or vegetables into the feeder tube. Use the food pusher, gently guide the food down to
the juice collector assembly. To extract the maximum amount of juice, always push the food pusher
down slowly.
IMPORTANT: DO NOT PLACE HANDS OR FOREIGN OBJECTS INTO THE FEEDER
TUBE. ALWAYS USE THE FOOD PUSHER.
5. If the pulp container is full it can be emptied during extracting. Turn the switch to speed ‘0’ and tilt the
pulp container from the pulp chute/ juice cover.
6. Insert the juice jug cover to separate froth being poured from the fresh juice extracted. If you prefer to
have juice with froth, remove the juice jug cover for direct fresh juice pouring.
DISASSEMBLE THE APPLIANCE
IMPORTANT: Before disassembling the appliance, make sure that the control switch is in the ‘0’
position, the plug has been removed from the wall outlet and the motor has completely stopped
operating.
1. Remove the food pusher from the feeder tube.
2. Remove the pulp container by holding onto the feeder tube and tilting the juicer slightly and take
out the pulp container.
3. Remove the juice jug.
4. Hold the pulp chute/ juicer cover and lift up the safety locking arms from the grooves on the side of
the pulp chute/ juicer cover.
5. Lift up to remove the pulp chute/ juicer cover.
6. Remove the spout cover (together with the stainless steel grater) by placing one hand under the
spout and another hand holding under the spout cover edge (opposite the spout) and lift it
upwards.
NOTE:
Be careful when handling the grater and filter assembly as the as the cutting blades are very
sharp.
Summary of Contents for EJE-A2050
Page 7: ......
