Elba EISF-G2601(BK), Owner'S Manual

Page: 4 / 8

4
INSTALLATION GUIDE
1. Open the packaging and remove the packaging material.
2. Unscrew the base locking screw and ring from the stand pole and insert the stand pole
through the hole in the centre of the base.
3. Tighten the base and stand pole by screwing back the ring and base locking screw.
4. Insert the round decoration cover from the top of the stand pole.
5. Loosen the screws on the extension pole and connect the extension pole with the
stand pole. Tighten the screws firmly and the height of the pole can be adjusted using
the adjustable screw knob.
6. The motor and connector have already been assembled, place the connector onto the
column holder of the stand pole, then tighten the bolts and nut with a wrench.
7. Ensure that the ground is level and firm before operating the appliance.
FAN BLADE AND GUARDS ASSEMBLY
1. Loosen the 4 screws on the face of the motor. Place the rear fan grill on to the motor
and fasten the screws with a cross screw driver.
2. Loosen the bolt on the fan blade and slide the fan blade on the motor shaft until firm.
3. Tighten the bolt and ensure the bolt sits onto the flat side of the motor shaft directly
when tightened.
4. Snap the front fan grill with the rear guard by connecting the guard clips firmly.