4
OPERATING THE APPLIANCE
1. Installation
Note: Do not switch on the power while installing the appliance.
Remove all the packaging.
Fig 1: You will find the following parts:-
1. Product body including water tank
1 pc
2. Steam head
1 pc
3. Flexible steam tube
1 pc
4. Hanger and hook
1 pc
5. Telescopic pole with clips
2 pcs
6. Brush - Standard brush and porous hair brush 1 pc each
7. Splint
1 pc
8. Instruction manual
1 pc
9. Warranty Card
1 pc
Fig 2: Install the telescopic tube into the product body.
Fig 3: Install the hanger to the telescopic tube.
Fig 4: To adjust the length of the telescopic tube, open the telescopic pole
clips.
Fig 5: Adjust to desired length and fasten the clips on the telescopic poles.
Fig 6: Connect the steam tube connector to the steam tube inlet.
Fig 7: Place the steam head on the hanger hook.
Note: Please install the brush to the steam head before operating the
appliance.
2. Fill up the water tank
Note: Do not fill the water tank with hot water!
Fig 8: This is the lid of the water tank.
Fig 9: Open the lid and then fill up the water tank with tap water. Do not fill up
the tank exceed the max level (refer the marking on the water tank).
Figure 10 and 11: Close the lid and hold the water tank as per the position
shown and then install to the product body.
