Elba AS E30-020, Instructions For The Use - Installation Advices

Page: 14 / 32

14
A
A
A
A
20
mm min.
40
mm max.
B
D C
30
mm min.
40
mm max.
D C
INSTALLATION
FASTENING THE COOKTOP
Each cooktop is supplied with a set of
tabs and screws to fasten it on units.
– Cut the unit (as shown in the figure on
the previous page).
– Stretch gasket “D” over the edge of
the hole made, being careful to over-
lay the junction edges.
– Turn the cooktop over and put tabs
“A” into the mountings; only tighten
screws “B” a few turns. Make sure
that the tabs are mounted correctly as
shown in the figures at the side. Turn
the tabs so that the cooktop can be
put into the hole.
– Put the cooktop into the hole cut into
the unit and position it correctly.
– Put tabs “A” into place; tooth “C” of
the tabs should go into the hole.
– Tighten screws “B” until the cook-
top is completely secured.
– Using a sharp tool cut off the part of
gasket “D” which protrudes from the
cooktop.
B
A
A
AS E30-040 - AS E30-050
AS E30-020
E30-040 - E30-050
E30-020, E30-021