11
1
1
3
Fig. 2.1
Caution!
The cooker becomes very hot dur-
ing operation.
Keep children well out of reach.
N.B. When the cooker top is not
being used, set the gas knobs to
their closed positions and also
close the cock valve on the gas
bottle or the main gas supply line.
LIGHTING GAS BURNERS FITTED WITH SAFETY VALVE DEVICE
(Semi-rapid and triple-ring burners)
Fig. 2.2
In order to light the burner, you must:
1 – Push and turn the knob in an anti-
clockwise direction up to the
position (maximum rate), push in
and hold the knob until the flame
has been lit (fig. 2.2).
The sparks produced by the lighter
situated inside the relative burner
will light the flame.
In the event that the local gas sup-
ply conditions makes it difficult to
light the burner in
position, try
again with the knob in position.
If there is no main electrical supply,
bring a lighted match close to the
burner.
2 – Wait for about ten seconds after
the gas burner has been lit before
letting go the knob (safety device
activation delay).
3 – Adjust the gas valve to the desired
position.
If the burner flame should go out for
some reason, the safety valve will auto-
matically stop the gas flow.
To re-light the burner, return the knob to
the closed
●
position,
wait for at least
1 minute
and then repeat the lighting
procedure.
If your local gas supply makes it difficult
to light the burner with the knob set to
maximum, set the knob to minimum and
repeat the operation.