©
Elation Professional
®
- www.elationlighting.com - SC-816™ User Manual Page 5
Power Supply:
The SC-16F controller can receive its operating power from the SC-
RP8 power pack when the SC-RP8 is plugged in to a wall outlet.
Set Up:
The SC-16F controller is linked to the SC-RP8 via the included 9-pin
com cable. It can also be linked via the LC Wireless controller (sold
seperately).
1.
Connect the supplied 9-pin com cable from the output of the SC-
16F to the input of the SC-RP8.
Note: The LC Wireless can also
be used in the connection, instead of the 9-pin com cable.
The LC Wireless is sold seperately.
2.
When using the provided 9-pin com cable, only plug the SC-RP8
power pack into a standard AC outlet. The SC-16F controller will
receive its operating power from the plugged in SC-RP8 power
pack.
When using the LC Wirelesss (sold seperately), both the SC-16F
controller and the SC-RP8 power pack must be plugged into a
standard AC outlet. The power supply that will be used by the SC-
16F controller is provided with the LC Wireless
3.
If desired, connect the 3-pin female XLR port of the SC-16F to the
3-pin male XLR port of a T16F.
SC-816™
Set Up
SC-816™
Operation
After setting up the SC-816 system, basic operation is very
simple.
1.
Be sure the main power is off on both units, and connect
your desired lighting effects to the power relay pack.
Notice: There are eight sockets corresponding to the 8 chan-
nels on the controller.
2.
Once you have connected your desired effects to the power
pack, you can use the Latch buttons to turn the fixtures on
or off. Or, use the Flash buttons to momentarily turn the fix
tures on and off.
©
Elation Professional
®
- www.elationlighting.com - SC-816™ User Manual Page 6
3.
You can also use the Pattern and Stand By buttons to select
chase patterns or scenes. The SC-16F controller must be
connected with T16F for this function. Pressing the
Stand By button for three seconds cand activate 17 chase
patterns or 7 fixed scenes. When chase patterns are acti-
vated, each tap of the Pattern button will select a chase.
SC-816™
Operation cont.
SC-816™ SC-816 Functions and Controls
1. Power Switch -
This switch turns the power on/off. When
the blue LED is lit, the power is on.
2. Strobe Speed -
Turning this knob allows you to adjust
the speed of the strobe. To increase the speed, turn
the knob clockwise. Turning the knob counter-clockwise will
decrease the speed till the strobe function “clicks” off.
3. Latch Buttons -
Pressing the desired button allows you turn
the corresponding channel on. This will be indicated by a lit
LED above the Latch and Flash channel button. Pressing the
button will turn that channel off. Thus, turning the lit LED
above the Latch and Flash buttons off.
4. Pattern Button -
This button is used with the T16F.
In master mode of the T16F, pressing this button can select
the chase pattern or scene. To utilize these functions, please
PIN
CH
VCC
1
2
3
4
5
6
7
8
9
5
6
7
8
1
2
3
4
CONTROL OUTPUT
FOG MACHINE
FOOT CONTROL STROBE OUTPUT
DC INPUT
+12V 300mA
PUSH
1
8
9 10 11 12
7
6
5
4
3
2