Elation Professional - www.elationlighting.com - ELED QA Strip Instruction Manual Page 10
Elation Professional - www.elationlighting.com - ELED QA Strip Instruction Manual Page 9
Master-Slave Operation:
This function will allows you to link units together to run in a Master-Slave
mode. In Master-Slave operation one unit will act as the controlling unit
and the others will react to the controlling units built-in programs. Any
unit can act as a Master or as a Slave however, only one unit can be pro-
grammed to act as the “Master.”
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit.
Use standard XLR data cables to link your units together. Remem-
ber that the Male XLR connector is the input and the Female XLR
connector is the ouput. The first unit in the chain (master) will use
the female XLR connector only. The last unit in the chain will use the
male XLR connector only.
2. Set the “Master” unit to your desired mode or operation.
3. For the “Slave” unit(s), set the display to any DMX channel mode.
4. Connect the “Slave” unit or units and they will automatically start to
follow the “Master.”
ELED QA Strip Master-Slave Configuration
mode, 54 Channel mode, and a 72 Channel mode. See pages 11-16 for
each modes’ DMX traits.
1. This function will allow you to control each individual fixture’s traits
with a standard DMX 512 controller such as the Elation® Show
Designer™ or the Elation® DMX Operator™.
2. To run your fixture in DMX mode, plug in the fixture via the XLR con-
nections to any standard DMX controller. Select your desired DMX
mode, and then press the UP or DOWN buttons to adjust the DMX
address.
3. DMX Channel Modes are as follows:
• To run the 1 Channel Mode, press the MODE button until “1
Channel DMX” is displayed. This is the DMX addressing for the 1
Channel Mode.
• To run the 2 Channel Mode, press the MODE button until “2
Channel DMX” is displayed. This is the DMX addressing for the 2
Channel Mode.
• To run the 4 Channel Mode, press the MODE button until “4
Channel DMX” is displayed. This is the DMX addressing for the 4
Channel Mode.
• To run the 5 Channel Mode, press the MODE button until “5
Channel DMX” is displayed. This is the DMX addressing for the 5
Channel Mode.
• To run the 7 Channel Mode, press the MODE button until “7
Channel DMX” is displayed. This is the DMX addressing for the 7
Channel Mode.
• To run the 8 Channel Mode, press the MODE button until “8
Channel DMX” is displayed. This is the DMX addressing for the 8
Channel Mode.
• To run the 36 Channel Mode, press the MODE button until “36
Channel DMX” is displayed. This is the DMX addressing for the 36
Channel Mode.
• To run the 54 Channel Mode, press the MODE button until “54
Channel DMX” is displayed. This is the DMX addressing for the 54
Channel Mode.
• To run the 72 Channel Mode, press the MODE button until “72
Channel DMX” is displayed. This is the DMX addressing for the 72
Channel Mode.
4. Please see pages 11-16 for DMX values and traits.
ELED QA Strip Operating Instructions
