ELAR PAR 72 UV
™
©Elation Professional, Los Angeles Ca.
25
www.ElationLighting.com
displayed as “11XX,” it stands for Channel 11 of the editing scene, the DMX value
is “XX.”
6. Adjust the DMX value by tapping the UP button, until you get the expected effect
for this channel.
7. Press ENTER to enter the editing of the other channels of the scene.
8. Repeat steps 5-8, until you finish setting all the DMX values for all the channels
of this scene, each scene can have 16 channels maximum.
9. Once all the channels are completed, the display will begin to flash “TIME,” this
indicates the time needed to run this scene.
10. Press ENTER to edit the time needed, the display shows
“
TXXX
”
,
“
XXX
”
represents the time needed to run this scene. For example,
“
T002
”
means
scene 1 needs 0.4 seconds to run,
“
T-15
”
means this scene needs 3.0 seconds
to run. Note: “XX
”
is always 0.2 seconds not one second.
11. Adjust the time needed by tapping the UP button.
12. Press ENTER to save the settings for the scene you are editing, the display will
change to the next scene automatically.
13. Repeat steps 3-12 to edit other scenes, you can edit and save 48 scenes
maximum.
14. Press MODE/ESC to exit and save your edited scene into the fixtures internal
memory. The number of steps can be defined under “EDIT” and the scenes can
be called up under “Run.” To run the scenes see page 30.
Editing procedure 2: Using an external controller.
1.
Call up the first scene in your controller now.
2.
Select “SC01” by pressing the UP or DOWN buttons.
3.
Press MODE/ESC, the display shows “SC01”.
4.
Press MODE/ESC, the display shows “C-01”.
5. Select
"CEDT" by pressing the UP or DOWN buttons.
6.
Press MODE/ESC, the display shows "OFF".
7.
Press UP, the display will read "ON".
8.
Press MODE/ESC, the display shows "SC02". You successfully downloaded
the first scene.
