1. Dual Edison Sockets:
These are dual 120V Edison sockets. Each set of
sockets is labeled with the relevant channel number.
Front & Rear Panel Overview:
1
2
3
4
5
6
7
8
9
2. Channel Output LED’s (1-4):
These LED’s indicate relevant channel activity.
3. Power indicator LED:
This LED illuminates when the power switch is ON.
4. Dip-switches:
Dip switches 1-9 are used to set the starting DMX
address channel and dip switch 10 is used to select
the packs operation mode. When dip switch 10 is set
to “ON”, the pack functions as a Switch pack. When
dip switch 10 is set to “OFF”, the pack functions as
a Dimmer pack.
5. DMX indicator LED:
When this LED flashes it indicates that DMX signal is present.
6. Power Line Cord:
This cord should be plugged into a 120V~60Hz AC socket. Be
sure that the plug service is capable of supplying up to 15Amps
to the pack.
7. Power Switch:
This switches the packs power ON & OFF.
8. DMX IN Connector:
This 3 pin male XLR input connector receives DMX signal
from a DMX controller or previous DMX fixture in the data link.
9. DMX OUT Connector:
This 3 pin female XLR output connector sends DMX signal to the next fixture in the data link.
Page 2
