DMX-Branch/4™ Operation
Be sure the power is disconnected before making any type of
connections Connect the output signal from your DMX control-
ler to the input jack of the DMX-Branch X4. Use the four output
channels to send DMX signal to your DMX fixtures. Dasiy-chain
the DMX output. Remember that the pack is only place a DMX
signal may be split. If you are not using the output jack to link
DMX-Branch X4’s together be sure the terminate switch is in the
in position
(Terminate)
.
Indicators:
Each of the four output channels have a set LED indicators, a
red and a green. Without an incoming DMX signal the red LEDs
will function as a power indicator. When a DMX signal is applied
the LED’s will serve two functions:
1. These indicator will indicate pin polarity. A solid red LED will
indicate pin 3 is hot (positive). A solid green LED will indicate
pin 2 is hot (positive).
2. When shorted or bad cable is connected to a particular chan-
nel the LED will turn off. This is useful to immediately identify
bad cables or lines.
©
Elation Professional
®
www.elationlighting.com DMX-Branch/4™ Instruction Manual Page 7
©Elation Professional
Elation Headquarters:
4295 Charter Street Los Angeles, CA 90058 USA
Tel: 323-582-2650 / Fax: 323-582-2610
web: www.elationlighting.com / E-mail: [email protected]
Model:
DMX-Branch X4™
SPECIFICATIONS:
Power:
110V/60Hz
Fuse:
5 x 100mA GMA
(Internal)
Working Position:
Any
Weight:
6.5 Lbs.
Size:
13” x 3 1/8” x 7 1/8”
Duty Cycle:
None