2
3
Caution:
Do not plug the IRE2 into an emitter jack that is set to HIGH Power
or “Blaster” as this will damage the emitter.
Attach Docking Station
to IR Sensor Window
w/Adhesive Strip
Slide Emitter into
Docking Station
IRE2 Properly Installed
Installation
• Locate the component’s IR sensor window. Thoroughly clean this
window to remove fingerprints, dust, etc.
• Peel the protective layer off of the adhesive strip on the docking
station and apply to IR sensor window.
• Orient the docking station vertically, then press down for several
seconds to ensure good contact with the adhesive.
• Slide the emitter down from the top into the docking station. It should
snap into place.
• Connect the 3.5mm plug into an ELAN multi-room controller, IRD4
Amplified IR Connection Block or other source of IR.
• Remove the emitter from the docking station by sliding it upward.
To 120V AC
(unswitched)
PWR2
Power
Supply
A/V Receiver
Satellite
DVD
IRS6
In-Wall
IR Sensor
IRE2 Talk-Back Emitter
Rear View
Connection
Terminals
IRE2 Talk-Back Emitter
IRE2 Talk-Back Emitter
IRD4
Amplified IR
Connection Block
6
Typical Installation
