Flush-Mount
The Flush-Mount Kit is used to acheive low-profile installations
where stealth and concealment are priorities. A hole must be cut in
the desired mounting surface.
To Install Camera Using Flush-Mount Kit:
1.
Cut a 3 1/4” diameter hole in mounting surface.
2.
Place camera inside of Camera Housing Base. Make sure wires
extend through Base.
3.
Place Camera Housing Top on Camera Housing Base and secure
with two 1/4” screws.
4.
Connect wires (see
WIRING
.)
5.
Place assembled Camera Housing into Main Bracket. Place
Bayonet Mount over Camera Housing and attach to Main
Bracket with three 1/2” screws. Do not tighten completely.
© 2004 ELAN Home Systems
6.
Place entire assembly into hole.
7.
Turn Winglet screws clockwise until Winglets are snug. Over-
tightening Winglets can keep trim ring from snapping in place.
If trim ring does not snap into place, loosen screws slightly.
8.
Make provisions to view the camera image and point the camera
at the desired location. Make sure that the image is level!
9.
With camera properly aimed, tighten screws.
10.
Align Trim Ring with slots in Bayonnet Mount. Snap in place.
11.
To remove Trim Ring, insert small, flat screwdriver tip into one of
three slots on outer edge and pry off.
P/N 9900435 REV:A Page 2
3 1/4" INCH
DIAMETER HOLE
Use 1/2" Screws
Use 1/4" Screws
MAIN
BRACKET
CAMERA
HOUSING BASE
CAMERA
HOUSING TOP
BAYONET
MOUNT
TRIM RING
REAR VIEW
FRONT VIEW
ACCESS HOLES
Access Holes are provided
to loosen Winglets in case
they become stuck.
