Notes:
Safety Notes
1. DMX console can not be used in Master-Slave operation (Sound Active or AUTO mode ).
2. There should be only one master unit in Master-Slave operation.
Troubleshooting
1. In Stand-Alone operation, if the power supply indicator is light up and sound active indic-
ator isn't light up, but the laser is shut off doesn't work, Please check if unit has been set up
in slave mode, then set up in master mode.
2. In Master-Slave operation, slave unit don't function, please check as below.
A. Make sure to there's only one master in the chain, and the others are set in slave mode.
B. Make sure to control the unit without DMX console controlling.
C. Make sure to take a good quality power cable and connection.
3. In DMX mode operation, the laser is OFF and the DMX signal indicator is unlighted, pl-
ease check as below.
Make sure to set up the DMX mode, make sure to have a good connection.
4. In DMX operation, the unit can’t be controlled by the DMX console, but the DMX signal
indicator is flashing, please make sure the DMX console and unit have the same channel.
5. If the unit is fail, please turn off the unit, then turn on again after 5 minutes.
After trying the above solution you still have a problem, please contact your dealer or our
company for service.
Page 12
Page 1
ANIMATION
LASER SHOW SYSTEM
SAFETY NOTES
Thank you very much for choosing our product, for your
safety, please read the laser safety instruction and this
manual carefully before your operation.
This manual includes installation and user information.
Please install and operate the laser according to the
requirements of this manual and safety guidelines.
DO NOT OVER DRIVE THE SCANNERS. WHEN USING MAX
SPEED KEEP THE ANGLE SMALL. FOR MAX ANGLE DO
NOT EXCEED 20000PPS ON THE ILDA SOFTWARE SETTING.
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER