MAINTENANCE
TROUBLESHOOTING
Replacing the filter
When the air purifier starts emitting a weak air flow, the
filter needs to be replaced.
The pre-filter can be cleaned using a vacuum cleaner or
similar equipment. The pre-filter can normally be cleaned
several times before replacing it.
The filter cassette cannot be cleaned without destroying the
filter class.
To replace the filter, loosen the screws on the top of the
air purifier (one screw for each filter holder). Then fold the
filter holder outwards and replace the filter.
To mount the filter, proceed in the reverse order.
Be careful with the seal mounted against the machine.
This seal should be cleaned when the filter is replaced.
Warning!
Troubleshooting should generally be carried out by the manufacturer,
the manufacturer’s service representative or another qualified
professional (e.g. a qualified electrician).
Abnormal noise
-
In the event of abnormal noise or vibrations, switch
off the machine immediately and make sure the fault
is repaired before the machine is restarted.
Contact El-Björn AB for consultation.
Cleaning
- Replace the filter according to the instructions
under ”Replacing the filter”.
- Clean with a mild soap solution and a damp
cloth.
Transport and storage
The air purifier should be transported and stored upright
(with the handle upwards).
The machine and filter should be kept as dry as possible.
The machine won’t start
-
Check that the fuses in the nearest electrical cabinet are
intact.
- Check that the rotary switch is switched on.
The machine emits less air than usual
- Check that the filter is not blocked. See page 15,
“Replacing the filter”.
If the filter is blocked, replace the filter and restart the
machine.
Each air purifier is thoroughly checked and tested before
leaving the factory. If any faults occur, please return the
machine, with handling and transport charges paid, to:
El-Björn AB
Depågatan 6
334 21 Anderstorp
Sweden
If, on examination, the problem is found to be caused
by a manufacturing or material fault, the machine will be
repaired free of charge and returned to the customer with
the handling and transport charges paid.
The guarantee is valid for 24 months from the date of
purchase.
GUARANTEE
When reporting a fault, please state the product’s serial
number.
This guarantee is not valid in the following circumstances:
1. If repair has been carried out or attempted by
someone other than El-Björn AB or a service point
authorised by El-Björn AB.
2. If the fault is due to normal wear and tear.
3. If the machine has been damaged due to carelessness
or accident.
4. If the machine has clearly been used incorrectly,
e.g. by loading it above the specified maximum
capacity.
5. If the machine has continued to be used after
partial damage occurred.
- 7 -
GB
Summary of Contents for LR500
Page 1: ...LR500 Manual...
