- 13 -
STEP 3
SCREW M3x10 AX1
STEP 3
Place nine (9) M3X10 AX1 screws into the water block standoffs and
tighten them using Philips head screwdriver (as shown in the image).
After attaching the AX1 Screws, three (3) terminal screws M4X20
DIN7984 needs to be attached using Allen Key 2.5mm.
Terminal badge can be reuse, after securing the terminal screws.
Pay attention not to use too much force when tightening the
active backplate down to the GPU PCB.
SCREW M4x20
DIN7984
TERMINAL
BADGE
For this step, you will need:
Allen Key 2.5mm
Phillips Head Screwdriver
STEP 2
STEP 2
Put two O-rings 14x1 EPDM 50 into slots on the copper plate.
Then carefully place active backplate on standoffs as shown in the
image. While putting the active backplate on the PCB, make sure the
O-rings stay in the slots.
Before attaching the Active Backplate on the PCB, make
sure all the Thermal Pads are placed correctly!
ACTIVE BACKPLATE
O-RING 14x1
EPDM50
