- 7 -
STEP 1
Install four (4) AM5 Mounting screws onto your motherboard. It is
mandatory to put a saved plastic washer underneath each of the
screws. Tighten the screws until you reach the end of the thread.
Using tools (such as pliers) is not recommended.
STEP 1
INSTALLING THE WATER BLOCK
STEP 2
STEP 2
Align the water block over the mounting screws on the motherboard.
Place a saved compression spring and thumb nut over each AM5
Mounting screw. Start fastening two thumb nuts at a time, preferably
in a cross pattern, and do not tighten them fully until all of them are
partially screwed in. Then - using your fingers only - screw in all four
thumb nuts until you reach the end of the thread.
THUMB NUT
SPRING
AM5 MOUNTING SCREW
PVC WASHER
