All disclosures, notices and warranty conditions are being written on EKWB web page. Please check terms of use.
Revision 1.0. Published on April 17
th
2019
STEP 5: CONNECTING THE RGB LED STRIP (optional)
CONNECTING THE D-RGB LED (LED with 3 wires)
Plug the 4-pin connector from Monoblock D-RGB LED strip to the motherboard.
Please ensure that the arrow indicated on the connector is plugged into the +5V
line as indicated on your motherboard. Failure to do so will damage your
motherboard or LED strip.
For the EK- MSI Z390 MEG ACE D-RGB Monoblock series water block to operate properly
the G1/4 port nearest to the right edge of the water block
MUST BE USED AS THE
INLET PORT
. EK recommends the use of EK-ACF fittings. When using fittings other than
EK-ACF series please use hose clamps or appropriate substitute to secure the tubing to
the barb.
The use of biocide containing and corrosion inhibiting coolant is always
recommended for any liquid cooling
system.
REQUIRED TOOLS AND MOUNTING SCREWS:
scissors
philips screwdriver
Allen key
Tubing
IMPORTANT: USE
THIS OPENING AS
AN INLET PORT!
