All disclosures, notices and warranty conditions are being written on the back of the box. Released on 16
th
of April, 2010. Revision 1.1
3.
PLACING STANDOFFS ON BLOCK. Standoffs are obligatory to make this block
fully functional and safe mounting. Please use small amount of thermal grease on
standoffs and glue them so they are concentric with mounting holes. Once they
are stuck to block be careful not to move them.
4. ATTACHING BLOCK TO GRAPHIC CARD. By using Philips screwdriver screw in
enclosed M3x8 screws. EKWB recommends start screwing the screws around the
GPU core and continue outwards.
STEP 4: CHECKING FOR CONTACTS
Temporarily remove the water block to check for uniform surface contact between the block and the components. Note the pattern of contact on a piece of paper. Then repeat
substeps in previous section to reattach the block. In case you can’t get good contact, please check again your thermal pad thickness our contact our support service.
STEP 5: POSITIONING FITTINGS
Please use spacer only on copper base if you use fitting with G1/4 thread longer than 5mm (see sample picture). Screw in the fittings and plugs (please use spacers only on
copper base for fittings). Use 6mm Allen key to screw in and tighten new EK-Plug G1/4. Attach the liquid cooling tubes and connect the water-block(s) into the cooling circuit.
EKWB recommends using high flow fittings with the EK-FC 480 GTX series water blocks. To ensure that the tubes are securely attached to the barb/fittings, please use hose
clamps or an appropriate substitute. The use of an algaecide is always recommended for any liquid cooling system.
You can use any hole as an inlet/outlet hole.
STEP 6: INSERTING CARD IN YOUR PC CASE
Carefully lift your card with installed block and insert it in your PC case. Please bear in mind that your card suddenly withstands extra weight thus again be very careful not to
bend it or cause any other unneeded moves that might damage your card or block during installation.
REQUIRED TOOLS AND MOUNTING SCREWS:
scissors
philips screwdriver
11 x screws M3x8 DIN7985
4 x M3x4 DIN7985
Fitting
Gasket/O-ring
G1/4
Spacer
Plug
Use 11 screws M3x8
Plug
6mm Allen key
Use 2 PVC washers with
these 2 screws. This
way you will diminish
possibility of damaging
PCB due to high screw
tension.