Step 5.
Please use 12 pieces of M2,5×6mm screws to install FB block as shown on picture 3.
Picture 3:
Installing the block.
Step 6.
Tighten all M2,5 screws equally and gradually to prevent the chipset cores from breaking, especially if
not using standoffs. Please be very careful while screwing over Mosfet area if you are not using Acetal
standoffs.
Step 7.
Remove the block and check for contact surface. Then repeat steps 3 to 6. And apply more or less
pressure on area where you have found it necessary.
Step 8
. Connect the water-block(s) to your water cooling system and attach the tubes. Any fitting can be used
as an inlet or outlet. To ensure the tubes stays properly on the fittings please use hose clamps or appropriate
substitute. The use of an algaecide is nonetheless recommended in any liquid cooling system.
Step 9
. Users who wish to replace top level 2 (bridge) can find enclosed red acrylic transparent top in the box.
While replacing it, please be very careful not to use too much force when screwing - acrylic is prone to
cracking, and damaging the threads in the top level 1 is very likely if using too much force on the screws. Also
make sure washer is well placed in the groove (channel).
HINT: When washer flattens equally all around and sits nicely in groove that is indicator that is being well
placed.
VERY IMPORTANT NOTICE
Once the installation is completed, it is always a good idea to test the circuit for leaks, prior to powering up the computer. We
recommend a 24 hour leak test prior to powering up the computer. Do not test the water block directly from city water pressure.
This will bow the top of the housing and render the block unusable (and will void your warranty).
IMPORTANT DISCLOSURES:
While all efforts have been made to provide the most comprehensive tutorial possible, EK Water Blocks assumes no liability
expressed or implied for any damage(s) occurring to your components as a result of using EK Water Blocks cooling products, either
due to mistake or omission on our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling products.
WARRANTY:
Our products are guaranteed for 24 months from the date of delivery to the final user against defects in materials or workmanship.
During this period, they will be repaired or have parts replaced provided that: (I) the product is returned to the agent from which it
was purchased; (II) the product has been purchased by the end user and not used for hire purposes; (III) the product has not been
misused, handled carelessly, or other than in accordance with any instructions provided with respect to its use. This guarantee does
not confer rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This
guarantee is offered as an extra benefit and does not affect your statutory rights as a consumer.
The guarantee is not valid if
there are used aggressive UV additives.
ADDITIONAL NOTICE:
USE OF STANDOFFS IS OBLIGATORY. FURTHERMORE , PLEASE DO NOT USE TO MUCH TIGHTENING FORCE ON THE 2 SCREWS AROUND SOUTHBRIDGE.ONLY IN THIS WAY
THE POTENTIAL DAMAGE TO YOUR MOTHERBOARD IS AVOIDED.
This notice is written upon the letter from EVGA RMA department. They state they will deny all RMA's if they find improper mounting method was used.
Top level 2
M2,5x6 screws