/ 28 /
EK-ATX
Bridging Plug
Power supply ATX Cable
RECOMMENDED FILLING AND LEAK
TESTING PROCEDURE
STEP 1
It is mandatory to do the following:
1. Disconnect all PSU power connectors (4/8-pin ESP, 24-pin ATX,
PCI-express power, SATA power) in your computer.
2. Plug the EK-ATX Bridging plug (enclosed) to your 24-pin ATX PSU
cable which allows jump starting your computer.
This procedure requires only the pump to be connected to the power
supply (PSU). Everything else needs to be disconnected!
These steps must be done to prepare the power supply for
the pump in order to fill the water cooling loop with coolant
and run a leak test.
Your system is now ready to be charged for the first time.
STEP 2
Connect the female EK-Cable Y-splitter connector to the male
connector header located on the motherboard. Always use CPU-
dedicated fan headers if possible.
Always use CPU fan header. On the majority of motherboards
these headers usually offer best PWM regulation.
STEP 2
STEP 1
