- 10 -
STEP 7: INSTALLING THE ASSEMBLY
OF FANS AND RADIATOR INTO A PC
CASE (AMD)
Attach the assembly of radiator and the fan(s)
to the PC case with the UNC 6-32 x 6mm
screws.
Radiator on top (recommended)
Vertical placement of the radiator with
tubing at the bottom (recommended)
STEP 5: MOUNTING-BRACKETS
INSTALLATION (AMD)
Use 4x M4x4 screws to install AMD bracket on
the pump unit.
Be careful not to touch or damage the pre-
applied thermal compound.
STEP 4: REMOVING THE COLD-PLATE
PROTECTIVE COVER (AMD)
Remove the protective cover from the
backside of the pump unit. It is there only to
prevent damage to the cold-plate and the
pre-applied thermal compound that is on the
cold-plate.
When removing the protective cover and
proceeding with installation be careful not
to touch or damage the pre-applied thermal
compound.
STEP 6: PUMP UNIT INSTALLATION
(AMD)
Wipe the CPU’s contact surface (using a
non-abrasive cloth or a Q-tip as shown in the
sample image).
Align the pump unit over the mounting screws
and CPU as shown in the picture.
Place the enclosed compression springs and
thumb nuts over the mounting screws (4x). Start
fastening two thumb nuts at a time, preferably
in a cross pattern, and do not tighten them fully
until all of them are partially screwed in.
Thumb Nut
Spring
Non-abrasive
cloth
IHS
Protective
Cover
Pre-applied
thermal
Compound
M4x4
AMD Mounting
Bracket
EK-AIO Nucleus 240
EK-AIO Nucleus 360
UNC 6-32 x 6 mm
(8x)
UNC 6-32 x 6 mm
(12x)
Summary of Contents for 3831109851708
Page 97: ...EK Nucleus AIO CR360 Vision D RGB CR240 Vision D RGB 115X 1200 1700 20xx CPU AMD AM4 CPU...
Page 109: ...110 NOTES...
Page 110: ......