- 12 -
STEP 3
STEP 3
ATTACHING THE I/O BRACKET
After attaching the water block, use two (2) M2.5 X 6 AX1 screws
and one (1) M2.5 nut to secure the I/O bracket to the PCB.
M2.5 x 6 AX1 SCREW
M2.5 NUT
STEP 2
M2.5 x 4 AX1 SCREW
PVC WASHER
STEP 2
ATTACHING THE BLOCK TO THE GRAPHICS CARD
Use thirteen (13) M2.5 X 4 AX1 screws and M2.5 PVC washers.
Tighten the screws evenly using the Phillips head screwdriver. EK
recommends you start tightening the screws around the GPU core
first and then continuing outward to prevent damage to the GPU.
Always use a plastic washer under each screw!