- 11 -
For the following steps, you will need:
M 2.5 PVC Washer
13 pcs
M2.5 Nut
1 pcs
M2.5 x 4 AX1
13 pcs
M 2.5 x 6 AX1
2 pcs
Phillips Head
Screwdriver
INSTALLING THE WATER BLOCK
STEP 1
PLACING THE BLOCK ON THE GRAPHICS CARD
Carefully position the water block with preinstalled standoffs on
the graphics card. During this process, make sure you have aligned
mounting holes of the PCB with holes of the water block.
Pay attention not to use too much force when pressing the
block down to the PCB since chip dies are prone to cracking.
STEP 1
6 mm
4 mm