4) Learn transmitter: Turn 6-gang, 7-gang to ON Position. Select the right regular from 1-4
gang. Then trigger the transmitter, the SEND indicator LED flick twice, it shows the learning
finished. When all the transmitter learned, turn to 7-gang to ON position, this repeater
works and just transmits the learned transmitter.
5) Delete transmitter: Before power on the device or in 15 seconds after power on. Turn 7-
gang and 8-gang to ON position. The SEND indicator LED flick 3 times. All the learned
transmitters are deleted.
V-Notice:
3) Set working mode: Connect to DV12V power supply, the POWER indicator LED will be on,
the repeater goes into working status. Adjust the DIP switch to select transmitting signal.
1 gang to 4 gang means transmitting siganls. (Note: Ther is only 1 gang allowd to be ON
position when it is working. If all the first 4 gangs are in OFF position, it repeat signal of
PT2262/4.7M)
1) Install the antenna to upwards, and do not put it near the metal things and wall.
2) This device is not waterproof.
3) If receiver cannot receive signal, please adjust distance between repeater and
transmitter, up to the repeater can receive the signal from transmitter, and then adjust the
receiver to the repeater.
4) Power supply is DC12V, output current is no less 300mA.
5) Before power on this device, please make sure 7-gang and 8-gang are not in ON position
at same time, or it will delete all the learned transmitters.
