eKoral eK Doser, User Manual

Page: 8 / 16

6.0. Schedule
6.1 eK Doser
1. After selecting the schedule tab, select the pump that the schedule will apply to and then
tap on the ​ ‘+’ ​ icon at the bottom of the page to start a new schedule.
2. Here you can select the amount of element you wish to ​ dose into your tank for your
selected amount of time ​ ( ​
Fig. 3 & 4, pg. 13 ​
) ​ .
3. Choose a time frame you wish for the schedule to take place; ranging from anywhere between
12:00am and 11:59pm ​ . You can preview your planned schedule before saving by tapping
“Start” ​ .
4. Select the day(s) of the week you wish for this schedule to occur. This can be as many or as few
as you wish.
5. Select the delay protection time you prefer. Tap ​ “Save” ​ to finish the schedule ( ​
Fig. 7, pg. 13
​
).
Delay-Time Protection: ​ The “Delay-Time” functionality delays both ​ ​ BEFORE ​ and ​ AFTER ​ ​ the dose
occurs. For example, if you set a 10-minute delay time on a dose, there will be a 10-minute delay
BEFORE the dose, and a 10-minute delay AFTER the dose, for a total of 20 minutes, in addition to the
time that the dosing takes.
If you dose frequently, we recommend that you account for this in your calculations.
7.0. Resetting your eK Doser
Attached to your system on delivery will be a reset pin. This is the piece of equipment that
enables you to reset the device ( ​
Fig. 1, pg. 8
​
).
1. Ensure that you want to reset
​
your eK Doser before proceeding with this process. Once
it is done you cannot restore the settings back to their original state.
2. Get the reset pin and locate the reset hole on your device. On the eK Doser it is on the
top next to the Status LED light.
3. Press onto the reset pin for ​ 10 seconds ​ and wait for the WiFi and Status LED lights to
turn off and start flashing slowly.
4. If the lights are flashing quickly (once or twice per second), press down into the hole
again for 1-5 seconds, until the WiFi light starts flashing slowly (approximately every 2
seconds). It is now ready to pair again.
7