EKOM DK50 2V/50/M, User Manual

Page: 55 / 220

AD DRYER
03/2022 55 NP-DK50 2V 50, 2x2V 110-AD-A-1_03-2022
Operator’s position. No specific operator’s position is required. The operator may remain within
range of a visual warning signal depending on actual operating conditions.
Low pressure . This signal is active when the dryer pressure sensor reads low pressure in the
dryer under the defined limit of 3 bar. An air leak from the compressor/dryer, malfunction of the
control solenoid valves on the dryer or a software error may activate this alarm during operation.
High pressure . This signal is active when the dryer pressure sensor reads an increase in
pressure over the high limit. The air pump will then shut down and remain shut-down until the
pressure decreases. If the air pump does not shut down, excess pressure is vented by the safety
valve on the compressor’s air tank.
High dew point . This signal is active when the dew point sensor reads a high dew point value.
Expiration of service interval . This signal is activated until service is performed and the interval
reset, or a new service interval is entered.
19. USER INTERFACE/SETTINGS
19.1. Meaning of symbols on the display
Symbol representing the user manual, or to read the user manual.
Symbol expressing the ambient temperature (from 25
o
C) related to the selected
mode.
The program adjusts the chamber pre-filling in the given mode.
Symbol expressing the ambient temperatu
re (from 25°C to 30°C) related to the
selected mode.
The program adjusts the chamber pre-filling in the given mode.
Symbol expressing the ambient temperature (over 30°C) related to the selected
mode.
The program adjusts the chamber pre-filling in the given mode.
Back to the main menu on the 4 main screens.
Go back.
Symbol for the service interval.
Symbol for when the dryer chamber is currently in regeneration.
Symbol for when the dryer chamber is currently drying.