FIREFRONT
This fire is supplied with a particular style of firefront. Use of the firefront will ensure an adequate airflow under the
fuelbed for the correct functioning of this appliance.
Compliance with safety standards cannot be guaranteed if another style of front is used.
CLEARANCES TO COMBUSTIBLES
A combustible shelf may be fixed to the wall above the fire, providing that it complies with the dimensions given below.
A non-combustible shelf may be fitted to within 10mm of the top edge of the fireframe.
Combustible materials, such as wood, may be fitted to within 100mm (4in) of either side of the frame of the appliance,
providing the forward projection does not exceed 100mm (4in).
Any combustible side walls must be at least 500mm to the side of the radiant heat source.
As with all heating appliances, any decorations, soft furnishings, and wall coverings (i.e. flock, blown vinyl and embossed
paper) positioned too close to the appliance may discolour or scorch.
VENTILATION
No purpose provided ventilation is normally required for this appliance.
The requirements of other appliances oper-
ating in the same space or room, and the results of a spillage test must be taken into consideration when assessing ven-
tilation requirements, this will have been carried out by your registered installer.
For Republic of Ireland, ventilation may be required, see IS 813, ICP3, IS 327, and any other rules in force.
OPERATING INSTRUCTIONS - manual models
The pilot is visible through the left hand side of the matrix. Rotate the coals/pebbles for
good viewing. Push in and turn the control knob to the SPARK position, and hold there
for a few seconds.
Continue turning anti-clockwise through the spark click to the PILOT light position,
ensuring the pilot has lit. If not, return the knob clockwise, and repeat.
When the pilot lights after the spark, keep the knob depressed for approximately ten
seconds. Now release the knob and the pilot should stay alight. If the pilot is extin-
guished during use, wait three minutes before repeating the ignition procedure.
To achieve the HIGH setting, push the control knob in slightly and continue turning anti-clockwise to the high position.
The main burner should light after a few seconds. To decrease the setting to LOW, turn the control knob clockwise to the
low setting.
To turn to the PILOT position from the HIGH or LOW positions, press the control knob in, and return to the pilot position
and release. To turn the fire OFF, keep the knob pressed in, return to the off position and release.
OPERATING THE FIRE - remote control models
Turn the main burner control (shown on left hand side of control
valve) knob fully anti-clockwise.
Turn ignition knob (shown on right hand side of control valve) slight-
ly left towards the ignition position until reaching the stop, press
down and hold for 5 seconds (only pilot gas is flowing)
Continue pressing down the knob while turning further to the left to
activate the piezo spark, continue to hold the knob down for a further
10 seconds after the pilot has been lit. If the pilot does not light
repeat the previous steps.
Upon lighting and after the further 10 seconds, release the knob and
turn further to the left to the ON position. The main burner will light
and be controlled in accordance with the main burner control knob
setting. Adjust the main burner control knob to the desired setting.
2
2.0
Maximum depth of shelf Minimum distance from inside edge of
fire frame to underside of shelf
100mm (4in)
203mm (8in)
150mm (6in)
305mm (12in)
203mm (8in)
356mm (14in)
3.0
4.0
5.0
5.1
©
2009 Focal Point Fires plc.
