EKF SC1-ALLEGRO, User Manual

Page: 66 / 83

User Guide • SC1-ALLEGRO •
CompactPCI ® Serial
CPU Board • Intel® i7-3xxx Processor
High Speed Expansion Connector J-HSE
High Speed Expansion J-HSE
GND a1 b1 GND
SATA_HSE1_TXP
5)
a2 b2 SATA_HSE3_TXP
4) 5)
SATA_HSE1_TXN
5)
a3 b3 SATA_HSE3_TXN
4) 5)
GND a4 b4 GND
SATA_HSE1_RXN
5)
a5 b5 SATA_HSE3_RXN
4) 5)
SATA_HSE1_RXP
5)
a6 b6 SATA_HSE3_RXP
4) 5)
GND a7 b7 GND
SATA_HSE2_TXP
4) 5)
a8 b8 SATA_HSE4_TXP
5) 6)
SATA_HSE2_TXN
4) 5)
a9 b9 SATA_HSE4_TXN
5) 6)
GND a10 b10 GND
SATA_HSE2_RXN 4) 5) a11 b11 SATA_HSE4_RXN 5) 6)
SATA_HSE2_RXP
4) 5)
a12 b12 SATA_HSE4_RXP
5) 6)
GND a13 b13 GND
USB_HSE1_P a14 b14 USB_HSE3_P
USB_HSE1_N a15 b15 USB_HSE3_N
GND a16 b16 GND
USB_HSE2_P a17 b17 USB_HSE4_P
USB_HSE2_N a18 b18 USB_HSE4_N
GND a19 b19 GND
USB_HSE_OC1# a20 b20 USB_HSE_OC34#
USB_HSE_OC2# a21 b21 USB_HSE_OC34#
+3.3VS
1)
a22 b22 +5VS
1)
+3.3VS
1)
a23 b23 +5VS
1)
+3.3VA 2) a24 b24 +5VA 2)
+12V
3)
a25 b25 +12V
3)
1)
Power rail switched on in state S0 only (Switched).
2)
Power rail on with system stand-by power (Always).
3)
Power rail switch off in state S5.
4)
This SATA channel is capable to perform up to 6Gbps.
5)
All TX/RX designations with respect to the SATA controller.
6)
This SATA channel was moved to the CompactPCI Serial Backplane with Rev.2 of SC1-ALLEGRO.
WARNING: The +3.3V/+5V/+12V power pins are not protected against a short circuit event. The
connector J-HSE therefore should be used only for attachment of an approved expansion side card.
The maximum current flow through these power pins should be limited to 0.5A per pin.
a1
s1
s9 s18
s10
a25 b25
b1
1.
00
mm
Pitch
High S
peed F
ema
le Con
ne
ctor
(H=8m
m
)
© EK
F
•
27
5.
90
.0
8.
06
8.
01
•
e
kf
.co
m
© EKF -66- ekf.com