2.
Browse to
Delete
and press the Menu button to delete the message
3.
After the delete, you will get back to the
Messages
menu where you can continue reading/delet-
ing messages or go back to the Main menu
Note
You can exit from the tag's menus whenever by pressing and holding the Menu button.
Tip
You can disable the tag's buzzer by entering the Main menu and selecting
Enable silent
mode
.
Tip
For more information on how to send messages to the B4 tag, please refer to Ekahau Vision
and Ekahau RTLS Controller User Guides.
4.4 Resetting to Factory Settings
The tag can be reset to factory setting with the following button sequence .
1.
Press and hold the Blue button until Right LED flashes orange. If the tag is busy this may take
even 20 seconds.
2.
Then immediately release the Blue button button and press down the Red button .
3.
After approximately 2 seconds both LED’s flash orange. If the tag is busy, it may flash only
the Right LED.
4.
The tag has now been reset to factory settings. The tag is in reset mode when it does not
execute button scan as defined in section
Button Activated Location Update and Maintenance
and pressing the Menu button does not turn on the display.
Note
Resetting the tag to factory settings removes all messages from its memory!
4.5 Firmware Update
The tag firmware can be updated wirelessly using ERC. The firmware is uploaded to the tags from
the
Tag Properties
page or directly from
Tags
page in ERC. Follow instruction in the ERC User
Guide for updating the firmware.
Chapter 4. Tag Operation
23
Summary of Contents for B4
