eka MKF 1016 S, Translation Of Original Installation And Maintenance Manual

Page: 12 / 16

11
4.6 Residual risks
Do not use the door handle to move the appliance: this may deform the door frame.
The appliance is fitted with electrical parts: it must never be washed with a water or steam spray.
The appliance is electrically connected: disconnect the power supply before performing any type
of maintenance.
To avoid incorrect connections of the appliance, the relevant electrical/water connections are
marked on the appliance by suitable identification plates.
Only for wheeled models
(MKF 1664 BM – MKF 2011 BM)
After installing the oven, ensure the tray trolley can be handled with ease, on smooth floors and
with no hindrance to insertion and extraction operations: the trolley is mounted on wheels, any
collision may cause the hot cooking food and/or liquids to spill and may even cause it to tip over.
5. TROUBLESHOOTING
6. TECHNICAL SUPPORT
Before leaving the factory this appliance has been calibrated and tested by experienced and skilled
personnel in order to obtain the best operating results. Any repair or calibration must be carried out with
the utmost care and attention, using only original parts.
That is why it is always necessary to contact the Dealer who sold the appliance or our nearest Technical
Support Centre, specifying the kind of failure and what model you have. For servicing needs the user may
contact Tecnoeka on the numbers shown on the cover, or refer to the website www.tecnoeka.com.
Type of fault Cause of the fault Corrective action
Control panel warning
lights totally off
(The oven does not work)
- Non-compliant connection to the
power mains
- Check the connection to the mains
- No mains voltage - Restore the power supply voltage
- Safety thermal device triggered - Restore the safety thermal device
Cooking cycle set: the oven
does not work
- Door open or ajar - Close the door properly
- Door sensor damaged - Contact a skilled technician
Automatic humidifier
active: no humidity/steam
production in the cooking
chamber
- Non-compliant water mains connection
- Check the connection to the water
mains
- Closed stopcock - Check the cock
- Obstructed water inlet filter - Clean the filter
- Damaged water inlet solenoid valve - Contact a skilled technician
Closed door: steam escapes
through the gasket
- Non-compliant gasket assembly - Check gasket assembly
- Damaged gasket - Contact a skilled technician
- Handle “nose” adjusted incorrectly - Contact a skilled technician
The oven does not cook
evenly
- One of the motors is down or operates
at low speed
- Contact a skilled technician
- The motors do not reverse direction - Contact a skilled technician
- Resistor not powered or damaged - Contact a skilled technician
Lamp (LED) in the cooking
chamber does not work
- Lamp (LED) damaged - Replace the lamp (LED)
The thermal safety device is
activated continuously
- Damaged device - Contact a skilled technician
- Control thermostat damaged - Contact a skilled technician