5
MAINTENANCE
MAINTENANCE AND CLEANING THE UNIT
• Make sure the area below the installation place is free from unwanted persons during setup.
• All screws used for installing the device and any of its parts should be tightly fastened and should not
be corroded.
deformation.
• The main cables must be in impeccable condition and should be replaced immediately even when a
small problem is detected.
• It is recommended to clean the front at regular intervals, from impurities caused by dust, smoke, or
other particles to ensure that the light is radiated at maximum brightness. For cleaning, disconnect the
main plug from the socket. Use a soft, clean cloth moistened with a mild detergent. Then carefully wipe
the part dry. For cleaning other housing parts use only a soft, clean cloth. Never use a liquid, it might
penetrate the unit and cause damage to it.
TROUBLESHOOTING
Problems
Possible causes
Checks and remedies
Fixture does not light up
•
No mains supply
•
Dimmer fader set to 0
•
Faulty LED
•
Faulty LED board
•
Check the power supply voltage
•
Increase the value of the dimmer channels
•
Replace the LED board
•
Replace the LED board
General low light intensity
•
Dirty lens assembly
•
Misaligned lens assembly
•
•
Install lens assembly properly
Fixture does not power up
•
No power
•
Loose or damaged power cord
•
Faulty internal power supply
•
Check for power on power outlet
•
Check power cord
•
Replace internal power supply
Contact an authorized service center in case of technical problems or not reported in the table can not be
resolved by the procedure given in the table.
FUSE REPLACEMENT
1. Disconnect this product from the power outlet.
2. Using a screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse and replace with a good fuse of the same type and rat-
ing (250V/T3.15A).
4. Screw the fuse holder cap back in place and reconnect power.
DMX CHARTS
12
9CH
Function
Value
Percent/Setting
1
Dimmer
000-255
0~100%
2
Dimmer Fine
000-255
0~100%
3
Red
000-255
0~100%
4
Green
000-255
0~100%
5
Blue
000-255
0~100%
6
Amber
000-255
0~100%
7
Lime
000-255
0~100%
000-010
No function
011-255
Strobe slow to fast
000-010
Preset LED Frequency from display menu
011-050
600Hz
051-100
1200Hz
101-150
2000Hz
151-200
4000Hz
201-255
25KHz
9
LED Frequency
8
Strobe