- 13 -
ATTACHING THE WATER BLOCK
STEP 1
Carefully position the water block with preinstalled standoffs on
the graphics card. During this process, make sure you have aligned
mounting holes of the PCB with holes of the water block.
Pay attention not to use too much force when pressing the
block down to the PCB since chip dies are prone to cracking.
Before attaching the PCB to the Water Block, make sure
all the Thermal Pads are placed correctly!
STEP 1
For this step, you will need:
Phillips Head Screwdriver
STEP 2
Use six (6) M2.5 x 4 AX1 Screws and PVC washers to tighten the
PCB on the water block. Tighten the screws evenly using the
Phillips-head screwdriver. After attaching the PCB, use one (1)
M2.5 x 8 AX1 Screw and one (1) M2.5 Nut to secure the I/O Bracket.
STEP 2
M2.5 PVC WASHER
M2.5 NUT
M2.5 x 4 AX1 SCREW
M2.5 x 8 AX1
SCREW
