- 11 -
CONNECTING THE D-RGB LED STRIP
STEP 1
Plug the 4-pin D-RGB connector from the GPU water block to the
D-RGB Header on your motherboard or controller. The LED strip will
work only if the pin layout on the header is as follows:
+5V, Data,
Empty, Ground
.
Incorrect installation or installation to a wrong header can
damage to the LED strip or the header itself.
STEP 1
D-RGB HEADER
RGB HEADER
For this Step, you will need:
STEP 4
AB TERMINAL
TERMINAL SCREW M4x27 DIN7984
STEP 4
Set the Active backplate terminal in place with the preinstalled
metal plate and secure it with four (4) M4x27 DIN7984 Screws.
Tighten them evenly with the provided 2.5 mm Allen Key.
AB Terminal with pre-
installed metal plate
Allen Key 2.5 mm
Terminal Screw
M4x27 (4 pcs)
27 mm
