- 11 -
STEP 2
M2.5 x 4 AX1 SCREW
M2.5 PVC WASHER
STEP 2
ATTACHING THE BLOCK TO THE GRAPHICS CARD
Use thirteen (13) M2.5 X 4 AX1 screws and M2.5 PVC washers.
Tighten the screws evenly using the Phillips head screwdriver. EK
recommends you start tightening the screws around the GPU core
first and then continuing outward to prevent damaging the GPU.
Always use a plastic washer under each screw!
For this Step, you will need:
M 2.5 PVC Washer
13 pcs
M2.5 x 4 AX1
13 pcs
Phillips Head
Screwdriver
INSTALLING THE WATER BLOCK
This procedure is the same for all full-cover water blocks.
STEP 1
PLACING THE BLOCK ON THE GRAPHICS CARD
Carefully position the water block with preinstalled standoffs on
the graphics card. During this process, make sure you have aligned
mounting holes of the PCB with holes of the water block (same
applies to other tops).
Pay attention not to use too much force when pressing the
block down to the PCB since chip dies are prone to cracking.
STEP 1
